Cleaning The Appliance; Technical Data - Beper 50.452 Betriebsanleitung

EN
Rechargeable vacuum cleaner 2in1 Use instructions
When cleaning is finished, turn off the appliance by pressing the on / off button again.
CAUTION: Switch off the appliance immediately if something gets caught inside the suction accessory.

CLEANING THE APPLIANCE

Clean the appliance body and the dirt container using only a soft, slightly damp cloth.
Make sure that no liquid enters the appliance.
Never use strong cleaning agents (stains, solvents) that could corrode the plastic.
How to empty the dirt container
CAUTION: Clean the dirt container and the filter after each use; the suction power will be reduced if the container
is full and / or the filter is clogged.
Disconnect the dirt container by pressing the button on the front of the container downwards and lightly pulling
the container downwards. Fig.1
Empty the container by pulling the appropriate lever on the lower part of the container downwards.
At this point it will be possible to remove the filter by turning the cap on the upper part clockwise towards the
symbol .
The filter is equipped with a removable and water washable sponge protection cover. It is recommended to allow
it to dry completely, in the air, before repositioning it.
The filter is not washable in water it is advisable to vacuum it or simply blow it to preserve its characteristics.
Once the cleaning operations have been completed, place the filter in its housing and close it by turning it anti-
clockwise . Make sure the filter and all of its parts are correctly positioned before reconnecting the container
to the main body.
How to clean the carpet / floor brush
CAUTION: Only clean the floor brush after removing it from the appliance.
Lower and pull slightly towards you the lever placed on the side of the lower part of the rotating brush.
Remove the rotating brush, proceed with cleaning and reassemble it correctly.
Close the lever by pulling it slightly towards yourself and at the same time pushing it downwards.
WALL SUPPORT:
The product is also equipped with a wall support and relative fixing screws. The support only helps to keep the
appliance sturdy when the tube and the brush are inserted. The appliance will not be attached to the support but
only supported.

TECHNICAL DATA:

Product:
Lithium battery 22,2V, 2200 mAh
Power supply:
INPUT: 100-240V 50/60Hz 0,5A
OUTPUT: 26,5Vdc - 500 mA
For any improvement reasons, Beper reserves the right to modify or improve the product without any
notice.
11