Control Settings - Danelectro FAB TONE Handbuch

•
Connect instrument cable to the IN jack. Connect amplifier
cable to the OUT jack. If using Danelectro AC Adaptor,
connect to DC 9-Volt jack. (Use only a 9-Volt adaptor for
this unit, not 18-Volt).
•
LED light will be on when foot switch is activated.
•
Control Functions:
VOL: This control sets the level of output to the amplifier.
BASS: Controls the gain of the bass frequencies.
TREB: Controls the gain of the treble frequencies.
FAB: Use this control to set the amount of distortion.
•
Caution: This is a high gain device. Start with the VOL
control at 25% and then advance as needed.
BATTERY: Uses one S-006P 9-Volt Battery. Danelectro "Vintage Power Source"
batteries are recommended.
Battery Eliminator: Uses 9-Volt battery eliminator. Polarity: Center negative (–).
300mA maximum.
2
F T D
AB ONE ISTORTION
TM
DD-1 I
NSTRUCTIONS

CONTROL SETTINGS

A
LTERNATIVE
VOL
FAB
BASS TREB
3