Herunterladen Inhalt Inhalt Diese Seite drucken

T&S B-1200-R Serie Installations- Und Wartungsanleitungen

Retro push-back glass fillers

Werbung

Verfügbare Sprachen

Verfügbare Sprachen

Limited One Year Warranty
T&S warrants to the original purchaser (other
than for purposes of resale) that such product
is free from defects in material and workman-
ship for a period of one (1) year from the date
of purchase. During this one-year warranty
period, if the product is found to be defective,
T&S shall, at its options, repair and/or replace
it. To obtain warranty service, products must
be returned to...
T&S Brass and Bronze Works, Inc.
Attn: Warranty Repair Department
2 Saddleback Cove
Travelers Rest, SC 29690
Shipping, freight, insurance, and other
transportation charges of the product to T&S
and the return of repaired or replaced product
to the purchaser are the responsibility of the
purchaser. Repair and/or replacement shall be
made within a reasonable time after receipt by
T&S of the returned product. This warranty does
not cover Items which have received secondary
fi nishing or have been altered or modifi ed after
purchase, or for defects caused by physical
abuse to or misuse of the product, or shipment
of the products.
Any express warranty not provided herein,
and any remedy for Breach of Contract which
might arise, is hereby excluded and disclaimed.
Any implied warranties of merchantability or
fi tness for a particular purpose are limited to
one year in duration. Under no circumstances
shall T&S be liable for loss of use or any special
consequential costs, expenses or damages.
Some states do not allow limitations on how
long and implied warranty lasts or the exclusion
or limitation of incidental or consequential dam-
ages, so the above limitations or exclusions may
not apply to you. Specifi c rights under this war-
ranty and other rights vary from state to state.
P/N:
098-003148-45 Rev.3
Date:
02-22-11
Drawn:
TEH
Checked:
JRM 04-01-11
Approved:
JHB 04-01-11
Installation and
Maintenance
Instructions
B-1200-R Series
Retro Push-Back
Glass Fillers
Deutsch:
Español:
Français:
Installations- und
Wartungsanleitun-
gen
la Instalación y las
Instrucciones de
Mantenimiento
les Instructions
d'Installation et
d'Entretien

Werbung

Inhaltsverzeichnis
loading

Inhaltszusammenfassung für T&S B-1200-R Serie

  • Seite 1 Installation and Maintenance Instructions Limited One Year Warranty T&S warrants to the original purchaser (other than for purposes of resale) that such product is free from defects in material and workman- ship for a period of one (1) year from the date of purchase.
  • Seite 2: Exploded View

    Exploded View B-1200-R B-1210-R...
  • Seite 3 Part Number Guide Retro Glass Filler Assemblies Asm, Glass Filler (B-1200-R thru B-1210-R) Asm, Body - Glass Filler & Pin † Washer 001030-45 003090-45 † Tip, Glass Filler 003199-45 † Screw, Handle † Nut, Handle 003198-45 † Lever Arm, Blue Lexan 001145-45 000714-25 Nut, Volume Control...
  • Seite 4: General Instructions

    General Instructions Installation: (B-1200-R) Installation: (B-1210-R) 1. Turn off water supply and drain 1. Turn off water supply and drain lines. Hand tighten no.20 fi rmly lines. against no.1 and remove no.21 from 2. Unscrew and remove no.26 and no.1. no.25 from no.23.
  • Seite 5: Instrucciones Generales

    Instrucciones Generales Instalación: (B-1200-R) Instalación: (B-1210-R) 1. Cierre la fuente principal de agua 1. Cierre la fuente principal de agua y y desagüe las tuberias. Firmemente desagüe las tuberias. aprete a mano la parte No.20 contra la 2. Destornille y remueva las partes parte No.1 y remueva la parte No.21 No.26 y No.25 de la parte No.23.
  • Seite 6: Instructions Générales

    Instructions Générales L’Installation: (B-1200-R) L’Installation: (B-1210-R) 1. Fermer la réserve de l’eau et 1. Fermer la réserve de l’eau et égoutter la tuyauterie. Resserrer par égoutter la tuyauterie. main Nº.20 fermement contre Nº.1 2. Dévisser et enlever Nº.26 et Nº.25 et enlever Nº.21 de Nº.1.
  • Seite 7: Allgemeine Anleitungen

    Allgemeine Anleitungen Installation: (B-1210-R) Installation: (B-1200-R) 1. Wasserzufuhr abstellen und 1. Wasserzufuhr abstellen und Leitungen entleeren. Leitungen entleeren. Mit der Hand Nr.20 fest gegen Nr.1 anziehen und 2. Nr.26 und Nr.25 von Nr.23 Nr.21 von Nr.1 entfernen. losschrauben und entfernen. Nr.24 so ausrichten, daß...
  • Seite 8 RELATED T&S BRASS PRODUCT LINE B-1230-R Water Station T&S BRASS AND BRONZE WORKS, INC. A fi rm commitment to application-engineered plumbing products 2 Saddleback Cove, P.O. Box 1088 T & S Brass-Europe Travelers Rest, SC 29690 ‘De Veenhoeve’ Phone: (864) 834-4102 Oude Nieuwveenseweg 84 Fax: (864) 834-3518...

Diese Anleitung auch für:

B-1200-rB-1210-r

Inhaltsverzeichnis