Native Technology BHS Serie Bedienungsanleitung Seite 5

5 MAIN LEVEL
This control adjusts the output volume of the system. Turn the knob clockwise to
increase the volume or counterclockwise to lower it. For optimal adjustment always
evaluate the acoustics of the environment and the musical genre.
6 SUB LEVEL
This control adjusts the output volume of the subwoofer and allows you to balance
the low frequency level, based on the acoustics of the venue. Turn the knob clockwise
to increase the subwoofer volume or counterclockwise to decrease it.
7 SIG/CLIP LED
Green LED: the signal is present in MAIN channel.
Red LED: the input signal is very strong and it's close to distortion.
If the red LED flashes continuously it's necessary to reduce the MAIN LEVEL or
reduce the levels of the devices connected to the LINE / AUX / TAPE inputs.
CAUTION: the system must never work with levels causing the CLIP red LED to
light up almost constantly.
8 ON LED
Il led ON si accende quando l'apparecchio è collegato alla rete elettrica e l'interruttore
di accensione POWER è posizionato su ON.
9 STEREO / MONO
This switch allows to select the system listening configuration in two different
modes: STEREO or MONO.
- Place the switch on MONO when connecting one cable to LINE INPUT L only, or
when you desire to listen in MONO; in this case all stereo signals present in inputs
are internally summed.
- Place the switch on STEREO when you use the system in a standard configuration;
in this case all the stereo signals present in inputs are addressed to respective
right and left speaker.
10 SUB PHASE (0°-180°)
Press this switch to invert by 180 degrees subwoofer phase, thus compensating
any phase cancellation due to venue acoustic, presence of more subwoofers or to
satellites with non-standard phase.
11 GND
Press this switch to reduce or eliminate electrical ground noise when connecting
signal lines between several appliances. It is very effective for eliminating ground
loops, but the actual result depends also on other connected devices.
BHS Series
8 User manual |
12 SATELLITE OUT L/R
Power outputs on 2-pole SpeakON connector for connection to the
speakers.
Use the SpeakON cables supplied with the system to send the signal to
left and right speakers.
CAUTION: Do not connect other speakers with different impedance to
these outputs. The use of speakers not suitable for the amplifier's load
capacity can irreversibly damage the unit.
13 SATELLITE INPUT L/R
Speaker input on 2-pole SpeakON connector.
These inputs must be connected to the SATELLITE OUT power output
of the corresponding left or right channel.
12
IMPEDANCE
8 OHMS
13
+1/-1 SIGNAL
BHS Series
| User manual
9