English - Bang & Olufsen BeoLab 17 Bedienungsanleitung

8
Set up your BeoLab 17 speakers wirelessly or
wired with cables hidden in the background.
Ensure that the speakers are positioned, set up
and connected in accordance with the
instructions in this guide and the guides
enclosed with any accessories. You may also
contact your retailer regarding installation.
Place your speakers according to your
1
preferences, however, note that the guide
enclosed, for example, with your stands or
brackets only describes one way of mounting
and you may have to adapt the mounting to your
setup.
Set up your audio/video product wirelessly
2
with a pair of BeoLab 17 speakers or make
a wireless surround sound system. See the guide
enclosed with your transmitter device, for
example BeoLab Transmitter 1, for information
about how to connect the transmitter device,
your audio/video product and your speakers.
If you choose a cabled setup, you can use
3
Power Link, Toslink or line-in cables for
TM
connection between your speakers and your
audio/video product. If you use TosLink cables,
you must make a daisy chain setup as illustrated.
This is also possible with Power Link cables. Be
aware that TosLink cables should not be bent
more than a radius of 30 mm, since this can
cause disturbances in the sound performance.

English

When handling your speaker make sure to
4
place it on a soft cloth or the like to avoid
making marks on the speaker.
To access the connection panel, switches
5
and product label, you must first remove
the end caps. Always remember to set the
position and role switches before mounting the
end caps.
Connect cables as shown on the
6
illustrations. Run cables according to the
instructions enclosed with your stands, brackets,
end caps, or bases.
RESET: Press and hold the button for a few
seconds to reset the wireless setting of a wireless
speaker. The status indicator is flashing green
quickly. The speaker is now in associate mode
and ready to be connected to the wireless
Power Link transmitter.
SERVICE: For service use only.
Set the position switch according to
7
whether your speaker is placed close to a
wall, a corner or in a free standing position. If
your speaker is placed in a bookcase, select
WALL or CORNER according to your preferences
regarding the sound performance.
Set the role switch according to whether
8
your speaker is placed to the left or the
right of your audio/video product, or whether it
is a wireless speaker.
Product status and wireless indicator:
9
– Red (solid): The indicator is solid red for some
seconds when the speaker is connected to the
mains, switches off, or when it restarts after it
has been reset .
– Green (solid): The indicator is solid green for
some seconds when the speaker switches on.
– Green (flashing): A software update is in
progress, during which the speaker cannot play.
Do not disconnect from the mains.
– Green (flashing quickly): If you have a
wireless Power Link transmitter in your setup,
the speaker is in associate mode and ready to
be connected to the wireless Power Link
transmitter.
– Orange (solid): The signal strength for a
wireless connection is low.
– Orange (flashing slowly): The product is
overheated and will shut down temporarily.
– Orange (flashing quickly): An error has
occured. Disconnect the speaker from the
mains and reconnect it or reset the network
connection if you have a wireless Power Link
transmitter. If the problem persists, contact
your Bang & Olufsen retailer.
Cleaning
Wipe dust off the surfaces using a dry, soft cloth.
If necessary, remove stains or dirt with a soft,
damp cloth and a solution of water and mild
detergent such as washing-up liquid.
Never use alcohol or other solvents to clean any
part of the speaker!