Fit the valve (4) onto the pipe (6) indoors.
Screw the fl ange (3) securely to the rear of
the panel (1) using the screws supplied (7).
Lift the panel (1) and insert the fl ange into
the pipe outside. Screw the panel securely to
the exterior of the building using the screws
supplied.
GB
cord for thermostat
1
1
24
Fit the thermostat
Remove the screw from the thermostat, tilt
the casing and remove it.
Mount the thermostat indoors in a location
where it can be reached by the cord.
Connect the cord to the thermostat's
terminals as shown on the next page.
Replace the casing on the thermostat and
secure it with the screw.
The system is now ready for use.
4
4
6
6
3
3