Werbung
Verfügbare Sprachen
Verfügbare Sprachen
EN
This product is suitable for installation in zones:
&
2
Outside Zone
All installations must comply with guidelines which are based on a
zonal concept. The diagram above illustrates this concept and must
be followed to ensure the safe installation of electrical appliances in
the bathroom. These regulations apply to domestic installations only.
Installations must be made in accordance with the current IEE wiring
regulations and relevant building regulations. We recommend that
all electrical bathroom products should only be fitted by a suitably
qualified, Part P registered electrician.
Installation
Ensure the domestic electrical mains supply to which the mirror
is being connected is turned off.
1. Position the mirror in a suitable location (according to the
zonal diagram - Fig. 1), ensuring that the domestic electrical
mains supply is within reach of the electrical entry point of the
product.
2. Carefully mark the position of the mirror using a soft pencil
ensuring it is level. Remove the mirror and mark the mounting
points. Please ensure that all marked mounting points
accurately match up with the fixing points on the mirror.
3. Using a suitable drill bit, drill holes in the marked positions to
a suitable depth. If drilling through tile, use a ceramic drill bit.
4. Insert wall plugs level with the surface of the wall. If fitting
to a tiled surface, wall plugs should be inserted below the
tile surface to avoid cracking. NB. For plasterboard walls,
specialist fixings should be purchased, available from any DIY
or hardware store.
5. Screw supplied fixings into wall plugs.
6. Connect the domestic mains supply to the terminal box
according to the wiring diagram overleaf (Fig. B).
7. Hang the mirror in position.
8. Switch the domestic electrical mains supply for the mirror
back on.
Operation Instructions
To switch on/off slowly move your hand past the sensor.
To alter the colour temperature of the mirror, hold your hand
by the sensor, the colour temperature will start to
change. Simply move your hand away from the sensor when the
desired colour temperature has been reached and continue to
operate the mirror as normal - the chosen colour temperature
will remain even after power is switched off and on again.
Care Instructions
Do not use abrasives or solvents when cleaning this product.
Wipe off all water spillages as soon as possible using a soft, damp
cloth.
Illuminated Mirrors
Luna 50
Art No. 221100
(Fig. 1)
Luna 90
Art No. 221102
Luna 140
Art No. 221104
Thank you for purchasing this product.
Please read through these instructions carefully and refer back to them during
installation to ensure that your product is fitted safely and that it retains its high
quality finish.
Please retain this leaflet for future reference.
Before installation, ensure the domestic electrical mains supply to which the mirror
is to be connected is turned off. Before drilling, ensure that there are no hidden
cables or pipes in the wall.
Mounting Points Diagram (Fig. A)
NB. These products must be installed with a minimum distance of 150mm between
the infra-red sensor switch and any adjacent wall or object to ensure correct
operation of the sensor.
Wiring Diagram (Fig. B)
Earth supply is Green and Yellow
LUMINAIRE
WEEE compliance
Must not be mixed with general household waste
/ Luna 60
Art No. 221101
/ Luna 120
Art No. 221103
Hanging landscape
REAR VIEW
mounting points
Li ve is Brown
live
ear th
Neut ral is Blue
neutral
Li ve supply can be R ed or Brown
Earth supply is Green and Yellow
Neut ral supply can be Blue or Black
MAINS SUPPLY
Werbung
