Troubleshooting - CANGAROO MISTY Bedienungsanleitung

1.Remove the tank from the base, unscrew the water tank cap. Fill the tank with water and screw back the cap.
Place the tank on the base. Make sure it is stable and completely fits.
2.Connect the power cord to the mains outlet. Turn the knob clockwise. The indicating light will turn green and
the appliance will start operating.
3.If you want to stop the appliance, turn on the knob counter clockwise. The indicating light will turn off and the
appliance will stop working.
4.You can adjust the needed mist level by turning the ON/ OFF knob. Turning clockwise wo;; increase the
humidity. Turning counter clock wise will reduce the humidity.
5.If you remove the tank from the base during operation, then the appliance will stop working. When you replace
the tank on the base, the appliance will start operating automatically.
GUIDELINES FOR MAINTANCE AND CLEANING OF THE BOTTLE WARMER
•Before use for the first time, clean well the appliance.
•Before you start cleaning the product, turn it off from the ON/ OFF switch, unplug the power cord and wait until
the appliance cools down.
•Do not use strong cleansers - bleach, alcohol based ones (anti-bacterial wet wipes) or such with abrasive
particles.
•After you clean the whole appliance, leave it to dry complete before you start using it again.
•Warning! Do not wet the bottom outer part of the base in order not to damage the electric parts of the product.
A. Cleaning of the transducer:
1.The transducer surface may become dirty after regular product use, especially if the water contains too much
limestone.
2.We recommend you to clean the transducer with clean, wet brush and mild detergent.
3.Spray the surface of the transducer with 2 to 5 drops of vinegar, depending on how dirty is the transducer.
Leave it for 2 to 5 minutes.
4.Use soft brush to remove the dirtiness on the surface. Do not use hard object or tool and do not scratch the
surface of the transducer.
5.Clean afterwards with water.
6.Do not use soap or other alkaline substances to clean the ultrasonic transducer.
B. Cleaning the water tank and the mist tube:
1.Clean the water tank and the mist tube at least every 3 days.
2.Remove the cap of the water tank. Pour inside the tank water solution and detergent. Place back the cap and
shake the tank well several times. Pour out the solution from the tank and wash well with water.
3.If there is scale in the water tank, use soft cloth and vinegar to clean it.
4.If there is lime scale on the safety switch, spray it with several drops of vinegar and clean it with brush. Clean
with fresh water.
5.The mist tube you can wipe with soft wet cloth and mild detergent. If there is lime scale on it, use vinegar to
clean it. Rinse with clean water.
C. Storage: If you will not use the product for a long time, clean it well and leave it to dry completely, before
storing it. Put it in a dry and airy place away from children reach.
Question
connected to the mains outlet
There isn't
any air or The appliance is turned off.
steam
There isn't water or too low quantity
Mist with
strange smell.
The water in the tank has not been

TROUBLESHOOTING

Cause
The power cord is not well
in the tank.
The appliance is new.
changed for a long time.
Answer
Check and connect correctly.
Turn it on.
Pour enough water in the tank.
Remove the tank from the base and drain out the
water. Leave the tank in a cool place without the cap
for about 12 hours.
Clean the tank and pour fresh water inside it.
12