Data Sending - Alcad 912-MS-Serie Installations- Und Programmierungshandbuch

28 - ENG
DATA
Output channel
Output frequency 47..894 MHz
Input frequency
Audio
Audio level
Video level
A/V ratio
Table channels
SCREEN
Data error
Reading error An error occurred during the READ function.
5.

DATA SENDING

5.1 Program mode
To program a modulator, turn ON the PROGRAM MODE programming
switch and the programming led will turn on.
programming a single receiver at a time.
Fig. 7 - Program mode
Installation and programming manual
VALUE
-
920..2150 MHz
Stereo/Mono/
Dual
1..4
1..8
12-16 dB
B/G CCIR
I UK SM8
D/K OIRT
L FRANCE
Frequency
Tab. 3 - Range of values
DESCRIPTION
The data selected does not belong to the range of
values indicated in table 3.
Tab. 4 - Warnings
The programmer will be ready to receive data from
the PS programmer while the led is on.
Once the modulator is programmed, the program
mode must be disconnected by turning the switch
OFF. The programming led will turn OFF.
DESCRIPTION
Values according to TABLE
Output frequency
IF band for input frequencyAudio
Stereophonic, mono or dual sound
Audio sub-carrier deviation
Video level
Difference between the levels of
the video and audio carriers.
Permits programming the output, using
channels from the selected table or
frequencies
We recommend