Honeywell 050162 Montage, Anschluss, Anleitung Seite 2

Mounting and Connection Instructions
Flush mounted box
Soldering distributor
Item no. 050162
General
Flush mounted distributor for connection
distribution box, switch box and cavity wall box
(i.e. milling hole Ø 68 mm) with 22 soldering
fittings and a cover contact (normally open
contact, NOC).
PCB-Board:
24 soldering fittings with 2 tongues
Component:
Cover:
Material:
Colour:
Technical data:
Environment class by VdS:
Protection category DIN 40050:IP 40
Contacts:
Screw bolt gap:
Cover contact:
Switching voltage:
Switching current:
Installation notes
When switching the soldering base points please
take care that the connection between soldering
base point and core is save and clean.
Honeywell Security Deutschland
Novar GmbH
Johannes-Mauthe-Str. 14
D-72458 Albstadt
1,5 mm
2 sealings with cover
Ø 80 x 3 mm
PA 6 with 30% optical fibre,
ABS
White
II
2,8 x 8 mm
60 and 68 mm
max. 30 V DC
max. 2 A DC
The carrying ring to be mounted to the flush
mounted box as said in the instructions (e.g. with
screws).
After the final mounting the cover screws must be
locked with screw sealings. The screw sealings
are to be found at the innerside of the cover.
Using a screwdriver the sealings may be
unlocked.
Installation aid
For quick and easy wiring of the distibutor board
during soldering; the board may be fixed to the
flush mounted box as follows:
Turn the soldering side of the distributor to the
backside of the distributor and fix the carrying ring
with one screw to the flush mounted box.
After soldering is finished, turn the distributor
to the box und mount it.
Connecting-List
CC
Subject to change
without notice
CC