Near Dark VAPORSENSE VS3 Bedienungsanleitung Seite 5

Battery Low
Safeguard
Charging
Charge your VAPOSENSE VS3 device for 1.5 to 2 hours initially. The power button will be red
while charging and will turn green once the battery is full.
Connect the AC/DC Adapter to your device then connect the other end to your power outlet.
Battery needs recharging when LED power indicator flashes rapidly or when the device outputs
less vapor.
(Pass through function cannot be used at the first 30min of charging when the battery pack is fully
discharged)
Instructions
To Lock/Unlock the VAPOSENSE VS3 vaporizer, press the power button(5) times consecutively.
Detach Mouthpiece/Chamber Connector to reveal the heating chamber.
Apply dry herbs into the chamber.
Attach the Mouthpiece/Chamber Connector back over the heating chamber.
Press the power button down for (3-5) seconds then release to activate heating chamber or to
deactivate it(The LED light will turn on showing a solid red light)
Wait for the power button to turn green, and then start to inhale slowly.
Cleaning and Maintaining
When using the VAPOSENSE VS3 for vaporizer for an extended amount of time, the mouthpiece
may become clogged and dirty resulting in a difficult draw or a lower amount of vapor being
released.
Clean Ceramic Heating Chamber: Use the brush tool to gently clean the walls of the Heating
Chamber.
Clean the Ceramic Filter: Use a paper clip or a pin and insert within the holes. Push All the way
through to ensure clear airway then wipe clean with a cloth.
Clean the Rubber Mouthpiece: Use a cotton swab and wipe the inner part of the rubber
mouthpiece then wipe with a damp paper towel.
Tips
For best results, do not over pack the ceramic heating chamber with your product. This will ensure
easy air flow passage for even heating.
In the event that vapor is not being released, use the packing tool to gently stir the product within
the chamber.
IMPORTANT INFORMATION: WARNINGS
BATTERY WARNING!
Unit contains Lithium-ion batteries, please be sure to discard of them in proper receptacle. Do not
dispose of in trash. Do not overcharge it; Do not short circuit it.
LED Flashes (4) times rapidly
Dual PCB/ IC protection