Inhaltsverzeichnis
Werbung
Verfügbare Sprachen
Verfügbare Sprachen
GB
Programmable Parameters
Please note: Parameters marked * are not applicable where non-
dimming ballasts are used.
Parameter
Options (Pre-set)
Power up
On / Off
Sets the luminaire state at power-up irrespective of occupancy. Useful
in reducing start-up load following power cut. Power-up off responds to
occupancy after 30 seconds.
Start-up Level*
Max / Min
Sets the level at which the lamps strike when switching on.
PIR operation
Auto / Semi-Auto
If set to auto, the presence detector switches the luminaire on and
off automatically. If set to semi-auto, the luminaire will not switch on
automatically when a person enters the area. It can be turned on using an
D HC5 or D HC6 hand-held controller or by toggling the power switch.
When the area is vacated, the light will switch off automatically.
Yes / No
Bright-Out*
If set to yes, movement fails to refresh the off delay if the ambient light
level is 125% of its desired level, and the luminaire will switch off when
the off delay has elapsed.
Yes / No
Min on Time
If set to yes, the luminaire is guaranteed to stay on for at least 20 minu-
tes, regardless of the off delay setting.
Off Delay
5-35 Min. / 20 Min.
The time for which the luminaire will stay on following the last detected
movement. Also 10 second setting for walk-testing.
Fade to Off*
Yes / No
When no presence is detected, and after the off delay has elapsed, the lamps can
fade to off instead of switching off (approx 80 seconds to fade from 100%).
When Vacant*
low / off / reg <25%
These are the options for a vacant area after it has timed out. Luminaires can
turn off, remain at minimum output, or regulate to a maximum 25% output, until
the next period of occupancy. If programmed to remain at minimum or regulate
below 25%, there is a programmable option to switch off after 3 hours.
Light level
1-100%, 100%
Can be set to regulate at any level within the light output range of the fitting.
Electrical Connections
Electrical Connections
PEHA Lichtsteuerung – PEHA Elektro GmbH & Co. KG a Honeywell Company · Gartenstraße 49 · 58511 Lüdenscheid · Deutschland · www.peha.de · peha@peha.de
Red
Black
White
Blue
Yellow +
Green -
115mm
DIL Switches
Ballast Type
Non-Dimming ON
1-10V
DSI
DALI
65mm
Supplied pre-wired to
the following plugs:
24V AC/DC
Metway GSK86502
Volt-free
output
Green
Yellow
Ballast
control
Blue
Black
White
Red
Wieland 25.380.3353.0
1
2
ON
ON
ON
ON
ON
OFF OFF ON
OFF OFF OFF OFF
3
4
ON
OFF
OFF
W4062G_DE_1204
Seite 7/8
Werbung
Inhaltsverzeichnis
