1. Construction
This system has 4 control buttons:
On/Off power switch
Up arrow to raise the temperature
Down arrow to lower the temperature
Light switch for the internal light
2. Setting Up the Cooler
a.Make sure the wine cabinet is on a hard, flat surface.
b.Insert the power plug into a 220 volt outlet.
c.The light will flash for 5 seconds and then will shine
continuously.
cooler will start to work and the On/Off button will show
a steady light.
d.The temperature display will flash and show the default
temperature (5°C). If this temperature is satisfactory,
after 3 seconds the wine cabinet will begin working and
the LED display will show the actual temperature
inside the cooler.
e.Allow the empty cooler to operate for approximately 1
hour to reach the desired temperature.
f.Fill the wine cabinet with wine bottles, allowing 1-2
OPERATION
Then push the button again.
The