Power Management System - Hansol D17CL Benutzerhandbuch

Introduction
System Flexibility
Equipped with DDC1, DDC2B and DDC2Bi for Plug & Play compatibility.
Monitor is compatible with VGA, SVGA, VESA and high resolution video modes up to
1280(H) 1024(V) @ 60Hz
Monitor may be used with IBM or compatible PC, MAC.
Automatic universal power supply is built in permitting AC power input of 100 - 240V AC,
50 or 60Hz.
Self-test menu allows the display unit to be checked on screen without connecting to a
computer.
Compact case minimizes desktop space giving you a large screen image without loss of
workspace.
Power cable included easily plugs into a standard outlet.

Power management system

This monitor complies with VESA, Nutek, and Energy Star power saving requirements. The
power saving system works only when used with VESA DPMS compliant PC's and/or graphic
controllers.
State LED
On Green
Stand by Green
Suspend Amber
Off Amber/Blink
The monitor goes into various power saving stages depending on the incoming
video signal as shown in the following table
State Horizontal Sync
On On
Stand by Off
Suspend On
Off Off
Note
The monitor automatically goes through the DPMS steps when it is idle.
To release the monitor from the DPMS condition, press any key on the keyboard or mouse.
6 User's Manual
Power Recovery Time
Under 75 Watts N/A
60 Watts 2 Sec
15 Watts 5 Sec
5 Watts 15 Sec
Vertical Sync
On
On
Off
Off
Connection to your computer
CAUTION
Ensure that both the PC and the display monitor are switched off.
Note : To attach the monitor to the Macintosh system, please contact an authorized
dealer.(Need to use a special adaptor)
Pin assignment table D-Sub Mini 15pin connector
Pin No. Assignment
1 Red Video
2 Green Video
3 Blue Video
4 Frame Ground
5 Ground
6 Red Video Ground
7 Green Video Ground
8 Blue Video Ground
9 N.C
10 Sync. Ground
11 Ground
12 SDA
13 H-Sync.
14 V-Sync.
15 SCL
Installation
To attach the monitor to your system, as
shown in the following illustrations.
1. Insert the AC power cord into monitor
and then into an AC power outlet.
2. Connect the signal cable to the 15pin
graphics connector of the system and
tighten the fastening screws.
3. To turn on the monitor, push the power
switch.
The 15-pin D-Sub connector
(male) of the signal cable
(IBM Systems) :
1 5
10
6
11 15
(15 Pin D-Sub)
User's Manual 7