Dekolight RF Wifi Box II Kurzanleitung Seite 4

Short Manual
Article No.: 843031
8. Connect and disconnect the Wifi Box with Kapego RF controller
a. Connect the Wifi Box with RF cnotroller
You have your tablet / smartphone connected with the WiFi Box and
selected your necessary virtual controller for your lghting system.
Your light source (eg LED Stripe) is connected to the RFcontroller.
Connect it with the power supply to the mains.
Once the light source begins to shine, press the Power button
on your virtual controller on your tablet / smartphone and keep it pressed.
The light source flashes three times and then lights up continuously.
You can now control the Light source over your virtual controller.
b. Disconnect the Wifi Box from RF controller
Disconnect the power supply to the connected RF controller and the
Light source from the mains. Then connect this again.
Once the light source begins to shine, press the Power button on your
virtual controller on your tablet / smartphone and keep it pressed.
The light source flashes nine times and then lights up continuously.
Now you can not control your light source with your virtual controller.
LED Overview
● Status LED lights up „green"
The operating voltage from the USB adapter is
connected to the WiFi box
● Status LED lights up „yellow"
The WiFi box is connected with any network
(Handy or Router)
● Status LED lights up „blue"
The WiFi box sends a remote control signal
to the controller
The product is CE compliant and meets all the essential requirements of Directive 2014/53/EU RED.
The CE Declaration of Conformity for this product can be obtained at the following address.
Deko-Light Elektronik-Vertriebs GmbH
www.deko-light.com / deko@deko-light.com
Technical Data can be changed without advance notice. Errors excepted.
https://shop.deko-light.com/
25.11.2019
1 / 2