Fitting / Removing Brush Heads; Cleaning And Care - Balance KH 120 Bedienungsanleitung

• To clean the chewing surfaces, direct the rotating brush head with
light pressure over the chewing surfaces.
• Finally, thoroughly clean the back parts of the molar teeth.
• On completion, press the Off switch
Note:
This appliance has a two minute timer. After two minutes the appliance
becomes slower, indicating to you that the dental profession recom-
mendation of two minutes has been complied with.
Important!:
In the beginning, it is common that the unfamiliar abrasion leads to
bleeding of the gums. This is normal. Should this continue for more
than two weeks, consult your dentist.

Fitting / removing brush heads

• You can remove the brush head
upwards.
• To replace the brush head
The brush head
damages, use only original brush heads.
(For replacement brush heads, see the order card)

Cleaning and care

After use, clean the brush heads thoroughly under running water.
For hygienic reasons we recommend that every 2 - 4 weeks you clean
the brush head with standard commercial cleaning fluids for dental
prosthetics.
q
q
must engage on being put back in. To avoid
e
.
q
by twisting and pulling it
use the inverse procedure.
- 16 -