Olympus DSS Player 2002 Installationsanleitung Seite 12

DSS Player 2002 INSTALLATION GUIDE
Connecting the DS-2000 Digital Recorder
Notes
• Make sure you finish installing DSS Player 2002 before connecting the DS-
2000. If you connect the DS-2000 before installing DSS Player 2002, the
"Add New Hardware Wizard" dialog box will open. If this happens, click on
[Cancel] to exit the wizard, then install DSS Player 2002 (
• Before connecting the USB cable to the DS-2000, make sure that the DS-
2000 is in the stop mode, with its rear-panel POWER/LOCK switch ON and
that the HOLD switch is not set to the HOLD position.
1
Insert end A of the USB cable to your PC's USB
port or USB hub.
2
Confirm that the DS-2000 is not in use before
attaching end b of the USB cable to the PC
terminal port of the DS-2000.
Notes
• Refer to the user's manual for your PC regarding
the USB port or USB hub on your PC.
• Be sure to push the cable connector all the way
in. Otherwise, the recorder may not operate
properly.
• Never remove the USB cable while a
communication session is in progress. Data files
could be damaged if you do.
12
P.7).