Maintenance - HoMedics SS-4500-2 Bedienungsanleitung

Setting and using the alarm
1. Press the ALARM SET button (Fig 5). The time will flash.
2. While the time is flashing press the HOUR button (Fig 5) until you reach the correct
hour. Then press the MINUTE button (Fig 5) until you reach the desired minute.
3. After 5 seconds the alarm set time will stop flashing and it will be programmed, or
you may press the ALARM SET button.
Note: The PM indicator also applies to the alarm. You can review the alarm
setting any time by pressing the ALARM SET button.
4. To activate the alarm you may choose one of 3 wake options:
a. To wake to RADIO (Fig. 5) press the AL MODE button (Fig. 5) once. You may
leave it on the current station or adjust the TUNER.
b. To wake to a SOUND, press the AL MODE button a second time. It will set to the
last sound you listened to. If you wish to change it, press the sound you wish to
wake to and then press the POWER button (Fig 5).
c. To wake to BEEP , press the AL MODE button a third time.
Note: The ALARM MODE indicator (RADIO/SOUND/BEEP) will appear on the
right side of the clock face (Fig. 5), and will indicate that the alarm is set.
5. When the alarm sounds, the corresponding ALARM indicator (RADIO/SOUND/BEEP)
blinks. You may either:
a. SNOOZE: Press the SNOOZE button (Fig 3). Your sleep time will be extended by
9 minutes. You may use this feature until you turn the alarm off.
b. RESET: Turn the alarm off by pressing ANY button on the unit, except for the
SNOOZE button (Fig 1). The alarm clock will automatically reset for the next day
in its current mode. The corresponding ALARM indicator (RADIO/SOUND/BEEP)
will indicate this. If you wish to change the wake mode follow step 1 under Setting
and Using the Alarm.
c. OFF: To completely turn off the alarm so it is not set for the next day, continue to
press the AL MODE button until all the ALARM indicators (RADIO/SOUND/BEEP)
are all off.
Note: If the alarm sounds for 30 minutes continuously it will automatically
turn off and reset for the next day.
8
Using the projection feature
1. To turn the projection feature on, slide the switch on the back of the unit (Fig 4) to the
ON position. The time is now projected on the ceiling.
Note: If the projection feature is off you may press the SNOOZE button (Fig 3) to
trigger 5 seconds of projection.
2. To turn the angle of the time that appears on the ceiling, rotate the TIME ROTATION
KNOB (Fig.1) until you have reached your desired result.
Note: The TIME ROTATION KNOB will rotate up to 350 degrees.
3. To focus the time on the ceiling, rotate the FOCUS KNOB (Fig 1.) until you have
reached your desired result.
4. The angle of the projector can be adjusted by angling forward or backward.

MAINTENANCE :

Storage
You may leave the unit on display, or you can store it in its box or a cool, dry place.
Cleaning
Wipe off dust with a damp cloth. NEVER use liquids or abrasive cleaner to clean.
Note: Modifications not authorized by the manufacturer may void users authority
to operate this device.
9