Troubleshooting - GGP ITALY BC 48 Li Gebrauchsanweisung

Separate collection of used products
and packaging allows materials to
be recycled and used again. Re-use
of recycled materials helps prevent
environmental pollution and reduces the demand
for raw materials.

7. TROUBLESHOOTING

Problem
1. String will not advance
using the auto-feed head.
2. Grass wraps around shaft housing
and string head.
3. Motor fails to start when switch
trigger is depressed
Possible cause
when String is welded to itself..
Not enough string on spool.
String is worn too short.
String is tangled on spool.
Cutting tall grass at ground level
Battery is not secure.
Battery is not charged.
Shaft not connected completely.
At the end of their useful life, discard
batteries
environment.
Lubricate with silicone spray.
Install more string, refer to string
replacement earlier in this manual.
Pull string while pressing line release
button.
Remove string from spool and rewind.
Refer to string replacement earlier in
this manual.
Cut tall grass from the top down to
prevent wrapping.
To secure the battery pack, make sure
the latch on bottom of the battery pack
snaps into place.
Charger the battery pack according
to the instructions included with you
model.
Make sure lower shaft is fully seated
in shaft coupler on upper shaft and
secure shaft coupler.
8
with due care
Solution
for our