Inhaltsverzeichnis
Werbung
Verfügbare Sprachen
Verfügbare Sprachen
Using the product
The functions described in this chapter are valid for the stand-alone scale. To
use the scale in combination with a compatible refrigeration system analyzer
(e.g. testo 556/560), please refer to the directions in the documentation of
the respective analyzer.
Switching t t he i i nstrument o o n:
Press
- Initialising phase (display test, display max. weighing range).
- Measurement view is opened.
With unstable readings (weight changes), the unit set blinks and the keys
are blocked as an entry is only possible with a stable reading (no change
in weight).
Tare s s cale ( ( measure n n et w w eights):
Taring is only possible in the > 0 kg / 0 lb range.
Press
key.
If the scale is in net mode, an arrow (
the display.
Zero s s cale / reset t t are
A zeroing is only possible in the 0±4 kg / 0±8.8 lb area. If the value is too
high,
, appears, if the value is too low,
Press
If the scale is at the zero value, an arrow is shown on the upper left in the
display (
).
Change u u nit:
Press
button repeatedly until the required unit is shown in the display
(kg, lb, lb:oz).
Holding r r eadings:
Hold down
right in the display.
Back to current reading: Hold down
out.
key.
key.
button until an arrow (
Using the product 5
) is shown on the bottom left in
appears.
) is shown on the upper
button again until
goes
Werbung
Inhaltsverzeichnis
