Werbung
Verfügbare Sprachen
Verfügbare Sprachen
Safety advices:
Installation and repairs to the device must be carried out exclusively by
a specialist in accordance with the applicable guidelines. No liability is
assumed for faulty installation and commissioning.
Before handling the device, remove the mains plug, otherwise there is
a danger to life. This also applies if you clean the unit or work on the
connections.
Only use the mains cable connected to the device. Never replace any
parts or make any modifications on the mains cable. Otherwise there is a
risk of mortal injury for which we cannot be held liable.
If a replaceable fuse is available, pull the mains plug before changing
the fuse. Replace damaged fuses only with standard fuses of the same
nominal value.
The device may only be operated in dry rooms. In humid rooms or
outdoors there is danger of short-circuit (caution: risk of fire) or
electrocution.
Choose the location of installation or mounting so that the power plug
can be reached and pulled out of the socket easily in case of danger.
Choose the location of installation or mounting such that children may
not play unsupervised near the equipment and its connections. The
location of installation or mounting must allow a safe installation of all
cables connected. The mains cable as well as feeder lines may not be
damaged or clamped by objects of any kind.
Choose the location of installation or mounting so that under no
circumstances liquids or objects can get into the equipment (e.g.
condensation, water coming from leaking roofs or flowing water, etc.).
To prevent damage to your equipment and to avoid possible peripheral
damages, the devices foreseen for wall mounting may only be installed
on a flat surface.
Avoid exposure of the equipment to direct sunlight and to other heat
sources (e. g. radiators. other electrical devices, chimney, etc.). Devices
that are equipped with heat sinks or ventilation slots must under no
circum-stances be covered or blocked. Also ensure for a generous air
circulation around the equipment. In this way you avoid possible damage
to the equipment as well as a risk of fire caused by overheating.
Absolutely avoid that cables come near any source of heat (e.g.
radioators, other electrical devices, chimney, etc.).
In case of damage, interrupt the power supply immediately.
Do not try to repair the device. This device should only be serviced or
repaired by qualified service personnel. Contact your distributor for more
information.
Do not open the device.
For disassembly always pull the mains plug first and disconnect the
power supply cable from the connected device.
State of the art 2020-02-12
Technical improvements, changes in design, printing- and other errors expected.
Technical data:
Type
SZU 99-15
(SZU 99-06)
General
Output voltage
Output current
2 A
Operation voltage
90...250 VAC / 47-63 Hz
Power consumption
39 W
Power consumption
0,4 W
open-circuit
Connector DC
Protection class
Herewith AXING AG declares that the marked products comply with the valid
guidelines.
WEEE Nr. DE26869279 | Electrical and electronic components must not be
disposed of as residual waste, it must be disposed of separately.
Manufacturer
EEA contact address
AXING AG
Bechler GmbH
Gewerbehaus Moskau
Am Rebberg 44
8262 Ramsen
78239 Rielasingen
SZU 99-14
SZU 99-22
SZU 99-22 | SZU 99-14
18 VDC
1,2 A
0,7 A
SZU 99-15 | SZU 99-06
25 W
18 W
0,3 W
0,2 W
premium-line
F-female
II
External power supplies
To be used only as spare parts
Operation instructions
Werbung
