Bartscher 2Z 126FL Original-Gebrauchsanleitung Seite 40


The temperature zones of the wine cooler are controlled independently with use of
control elements.

Pressing ON/OFF

on the upper control panel: device and upper temperature zone;

on the lower panel: lower temperature zone.

The digital display shows current average temperature for a
given temperature zone.

The buttons
settings: from 5 °C to 20 °C in the upper and lower temperature zone.

Recommended storage temperature for white wine: 6 °C - 10 °C,
for red wine: 12 °C - 18 °C.

If both temperature zones are used, the temperature in the upper zone should be
lower than in the lower zone.

The lower temperature zone may be deactivated so only the upper zone remains
active.

Wait until the device reaches the preset temperature and put the wine bottles inside.
Hint: Keep in mind that in case of maximum load of the device chambers it must
work longer to reach the preset temperature.
When preset temperature (e.g. 20°C) is reached, in the bottom and
on the right side of temperature value "c" character appears.
When preset temperature (e.g. 5°C) is not reached yet, the
character "c" is displayed in the top and on the right side of
temperature value.

By pressing two buttons
switch between °C and °F.

With use of buttons

Button is used for turning on and off the internal
light; LED lamp is installed under the ceiling of a
given chamber.

Temperature in the device depends on environment, number of stored bottles, and
preset temperature.
- 36 -
button allows for turning on
and are used for adjustment of the following temperature
and
and it is possible to adjust temperature every 1°C.
simultaneously for 5 seconds it is possible to