Mounting Instructions; Light Sources - Ferm TREE LAMP Montageanweisungen

INFORMATION - UK
The lamp is used exclusively for lighting
mounted on the wall, and is to be installed
in accordance with the national installation
regulations. Any other use is regarded as not
according to instructions. Verify that product
ratings meet supply ratings before installing
the luminaire. We recommend to attach the
wire to the wall, as loose wires may cause
a strangulation risk to babies and small
children.
DATA
Wood
Plywood with front in
smoked oak veneer or
paint
Plastic cover
Opal polycarbonat
(opal Lexan 940)
Connection
AC 220-240V 50/60 Hz
with LED driver
IP code
IP20

LIGHT SOURCES

LED examples
Non Disassemble
dimmable plastic cover
when replacing
light sources
4
Light sources
LED only
Wattage max. 2 x 3W
Voltage: 12V
Lamp socket: G4
LED driver
AC 220-240V 50/60 Hz
DC 12Volt, 12W power:
1 Amp.
Driver Stand by
consumption
Power: 0,0W
No halogen light
source

MOUNTING INSTRUCTIONS

1
2
3
4
5
1. Place the lamp
socket on the wall
and secure it with
two of the included
screws
2. Put in two LED
light sources
3. Take the plastic
cover and place it
above the LED light
sources
4. Fasten the plastic
cover to the lamp
socket with two of
the included screws
5. Take the front of
the lamp and slide
it down on the front
area on the lamp
socket. Connect the
LED driver to the
lamp and then to the
supply