Using The Dragon Touch Dt40 Baby Monitor - Dragon Touch DT40 Bedienungsanleitung

③ Press the "-" Left Button or the "+" Right Button to select the desired CAM and press
the OK Button to start searching for a Camera Unit.
④ Press and hold the PAIR key behind the Camera Unit for at least 3 seconds. Then the
connection is successful.
10

USING THE DRAGON TOUCH DT40 BABY MONITOR

1. Set Up
Place the Camera Unit in a convenient location (e.g. on a table or a shelf) and point the
camera lens toward the area you want to monitor.
Note: Do not place the Monitor Unit within baby`s reach. If there is interference with the
picture or sound, try moving the units to different locations, and ensure they are not close
to other electrical equipment.
2. Volume Setting
① Press Menu Button and the menu bar will pop up. Press the "+"
Left Button until Volume icon is highlighted.
4.3" LCD
28°C
② Press OK Button to enter to the interface. Press the "+" Right Button or "-" Left Button
to adjust the volume.
4.3" LCD
28°C
Right Button or "-"
CAM-1
OK
CAM-1
OK
11