Troubleshooting - A.M.P SP zero Bedienungsanleitung

Start Listening
For optimal sound, place your SPzero on its base (with the A.M.P. logo on
the bottom) facing towards you (with the front panel LED indicator facing
you). When connected via Bluetooth, it is best to have the media device
set on max volume and further adjust volume using the "+" and "-" buttons
located on the top of your SPzero.
If you choose to use the auxiliary cable (3.5 mm), please make sure that
the volume is turned down before operation. This will reduce overdrive on
the SPzero which causes audio distortion.
Socializing
The SPzero can be used as a wireless speakerphone. The integrated
microphone will only function via Bluetooth connectivity.
Music share via daisy chain function
1. Aux-Out the Paired Master SPzero, then Aux-In to another SPzero.
2. Repeat Step 1 to Daisy-Chain multiple SPzero.
EN
Answer/End Calls
Press the center button to Answer and End calls.
To Make a Call
Use your phone to dial. Your SPzero will function as a speakerphone.

Troubleshooting

The device is malfunctioning
• Always check for proper charge and make sure that the device is On
The device is creating distortion or the sound quality is poor
• Lower the volume on the SPzero and increase the volume on your phone or device
• Connect the SPzero directly to your device using the 3.5 mm auxiliary cable
• Check the charge of the SPzero and your mobile audio device and recharge
if necessary
• Re-pair the devices using the instructions listed under the "Pairing Mode" section
The SPzero fails to pair with Bluetooth enabled device
• Confirm that your device is Bluetooth compatible and that the Bluetooth
setting is enabled
• Re-pair the device following the instructions listed under the "Pairing
Mode" section
The signal drops or connection fails in Bluetooth mode
• Move the SPzero closer to your mobile device
• Ensure the SPzero is fully charged
• Turn off the SPzero , wait one minute, power it back on and reconnect to
the Bluetooth-enabled device using the instructions listed under the
"Pairing Mode" section
Notice: Avoid placing SPzero near the edge of surfaces since it may shift during use and fall
over. Warranty does not cover physical damages as a result of such falls and other mishaps.
EN