Werbung
Verfügbare Sprachen
Verfügbare Sprachen
8020-320 Table Stand for GENELEC 8020A / 8020B
Instructions
The table stand is ready for set up.
Four bumpons 1 keeps the monitor free
from gliding and vibrating.
Furthermore it safes the desk from scratches.
MONITOR MOUNTING
- Set up table desk 2.
- Bolt together the monitor with the stand.
-
Use both pan-head-screws 3 M6 x 12 mm.
- Connect cords 4 with the monitor.
TILTING
- The monitor plate 5 can be tilted continuously
-
about 20° backwards.
- Hold the monitor, loosen the wing bolt 6 a little
-
and tilt the monitor 7 into desired position.
-
Then tighten the wing bolt 8 again.
Safety instructions
- only for GENELEC 8020A / 8020B
- Inspect bolted assemblies regularly.
- For use only on even surfaces.
NOTE for model 8020A:
while using this table stand the monitor's
XLR-output-connector is not available.
76 mm
GENELEC Oy
Olvitie 5, Fin-74100 Iisalmi, www.genelec.com
23274-000-56/63/68 Rev.02 03-80-409-00 2/13
Werbung
