Cleaning The Oven Door - Zanussi ZOU 363 Bedienungsanleitung

Cleaning the Oven Door

Before cleaning the oven door, we recommend you to
remove it from the oven.
Proceed as follows:
1. open the oven door completely;
2. find the hinges linking the door to the oven (Fig. 1);
3. unlock and turn the small levers located on the two
hinges (Fig. 2);
4. handle the door by its left- and right-hand sides, then
slowly turn it towards the oven until it is half-closed
(Fig. 3);
5. gently pull the oven door off its site (Fig. 3);
6. place it on a steady plan.
Clean the oven door glass with warm soapy water
and a softh cloth only. Never use harsh abrasives. Once
the cleaning is carried out, refit the oven door, following the
procedure in reverse.
Stainless steel or aluminium appliances:
We recommend that the oven door is only cleaned
using a wet sponge and dried after cleaning with a soft cloth.
Never use steel wool, acids or abrasive products as
they can damage the oven surface. Clean the oven control
panel following the same precautions.
DO NOT clean the oven door while the
glass panels are warm. If this precaution is
not observed the glass panel may shatter.
If the door glass panel becomes chipped or
has deep scratches, the glass will be
weakened and must be replaced to prevent
the possibility of the panel shattering.
Contact your local Service Centre who will
be pleased to advise further.
Oven Shelf Support Rails
The shelf support rails on the left and right hand sides
of the oven can be removed for cleaning the side walls.
Removing the shelf support rails
First pull the front of the rail away from the oven wall
and then unhitch at the back (Fig. 4, Fig. 5).
Fitting the shelf support rails
To install, first reattach the rails at the back, then put
them into position at the front and press them into place
(Fig. 6).
To clean the shelf support rails, soak in warm soapy
water and remove stubborn marks with a well wetted
soap impregnated pad.
Rinse well and dry with a soft cloth.
Fig. 1
Fig. 2
Fig. 3
Fig. 4
Fig. 5
Fig. 6
27