Samsung SSA-R2000 Kurzanleitung Seite 5

Installation and External Connection
INSTALLATION
1. Attach the provided wall mount to the wall and drill two 6-32 holes and one
1/2 inch hole on it. (See [Figure 1])
2. Refer to [Figure 2] below on how to secure the wall mount to the wall using
the provided screws.
3. Apply each of 5 O-rings to the corresponding point as shown in [Figure 2].
4. Fix the main unit with the wall mount by inserting the main unit's cables into
the center hole and pushing the main unit towards the wall mount.
O-ring
O-ring
O-ring
1.52"(38.5mm)
3.03"(77mm)
[Figure 1]

J
Once the main unit is fi xed with the wall mount, it will not be loosened. Please
check if the device is operating properly before fi xing it.
If you try to remove the wall mount once it is fi xed, the lock parts of the wall
mount will break, resulting in a situation where the whole wall mount must be
replaced.
6-32 hole
O-ring
1/2" hole
6-32 hole
O-ring
1.52"(38.5mm)
QUICK GUIDE
[Figure 2]
English_
5