MW LEX0310 Anweisungen

LEX0310
INSTRUCTIONS / ENGLISH
Functions:
Switched power supply
Features 6 outputs
Power: 60W max
Switch-adjustable output voltage 6 / 7,5 / 9 / 12 / 13,5 / 15V DC
Input voltage: 100/240V – 50/60Hz
Output current:
Output voltage
6/ 7,5/ 9/ 12V
13,5/ 15V DC
Precautions:
1/ Do not use outside; do not expose to dust, fire or heat; do not get wet or moist; do not dismantle or
open (take it to a qualified repair technician). Do not cover while using.
2/ Keep out of reach of children; do not insert metal objects (screwdrivers, wires...).
3/ Keep in a dry place and do not use with wet or moist hands.
4/ Do not use if the power supply has been damaged.
5/ Do not change the output voltage when the power supply is connected to the mains and when your
application is connected to the power supply.
6/ Do not short-circuit or reverse the polarity.
Instructions:
1/ Before connecting the power supply to the mains, adjust the output voltage so it corresponds to the
application voltage.
2/ Verify that the current needed to operate your application corresponds to the current delivered by the
power supply: see the table above.
3/ Select the output plug that corresponds to the size of your application connection.
4/ Make sure the polarity shown above the plug corresponds to the application polarity (refer to the indi-
cations directly on your application or in the corresponding instructions) by aligning the arrows on the
connectors as shown in the diagram below. Then connect the plug to the power supply adaptor cord.
MORE TO THE CENTRE
5/ Connect the power supply to the 100 - 220 V mains socket, then connect the power supply plug to your
application. Start your application.
6/ If the application malfunctions, check whether the polarity has been reversed.
7/ Disconnect the power supply from the socket after use, then disconnect the power from your appli-
cation.
Imported by Enix Energies - 27 rue des Glairaux - 38120 Saint-Egrève - FRANCE - www.enix-energies.com
Output current
5000mA
3800mA
LESS TO THE CENTRE