Product Specification - Rnd Lab Rnd 560-00219 Bedienungsanleitung

Product Specification

Boot
Plug the power cord connector into the AC connector on the back of the machine and plug the power cord
into a power outlet.
Turn on the power switch on the back of the machine and the soldering iron starts to warm up.
At this point, you can use the
to select the temperature you want.
Temperature setting function:
three sets of temperature program settings
The setting method is as follows:
First use the middle
press the SAVE button and then press the number you want to store. When the storage is successful, there
will be a display above the number of the display. The table temperature setting is stored.
Use the same method to adjust to the desired temperature. First press the SAVE button and then press the
number you want to store to store the other two sets of temperature memory. This unit can provide three
sets of temperature memory for users to use.
other functions:
1. Temperature correction function:
Press SET and at the same time. The blue number in the lower right corner of the display starts to flash. You
can use to adjust the temperature correction. This unit can provide temperature correction of ±50°C.
When the correction is completed, press ENTER to confirm.
2. Set the standby time:
Press SET and at the same time. At this time, the blue number in the lower right corner of the display starts
to flash. You can use
Set the standby time to enter the standby state from 000 seconds (not automatic sleep standby) to 999
seconds. After the input is completed, press ENTER to confirm.
The standby time starts from the time when the soldering iron is placed in the rack.
When entering standby mode, the display will show --- and the moon sign will be displayed on the left, which
is the sleep standby state.
keys to adjust the temperature you want, or use the set of
button to adjust to the temperature you want to set. After the temperature is set,
to adjust.
EN
settings
3