YI Mirror Bedienungsanleitung Seite 4

3)、Wiring lnstallation Diagram
Installing the device
1
2
Open the strap at the Place the device in the
bottom of the rearview center of the rearview
mirror mirror, and lock the strap
from the top to the bottom
Tip: Make sure you use the correct USB car charger model before using YI Dash Camera.
In some cars, the USB car charger is on even after the engine is turned off, and it consumes
battery. If this is the case, please turn off your camera manually after you switch off the engine.
3 4
Install the power cable Insert the car charger into
around the trim of your your vehicle's cigarette
vehicle lighter port and connect
the USB cable
Rear Camera Installation
Camera unit
1. After receiving the product, please check if it works properly before installing.
2. If you want to automatically switch on the car rear view back-up camera, and switch
on light when backing the car, you must connect the red back-up cable to the "+"
terminal of the car's back-up signal lamp.
3. Take the help of a professional to install the device. Before installing, please confirm
if there are any tiny adjustments required.
Connect the red cable to the positive
terminal of the indicator light.
6-meter extension cord