Troubleshooting; Specifications - Ideen Welt K 1216 N Bedienungsanleitung

TroUBLESHooTING

If you experience any problem with this system, review the list below before you contact the customer
service.
WArNING: Never open the device. Always refer service or maintenance to authorized customer
service personnel.
ProBLEM
The player doesn't work
No sound from the earphones.
No sound.
No sound when using the
microphones.

SPECIFICATIoNS

General
Power Supply:
AC-DC adaptor:
Battery operation:
Dimensions:
Net weight:
Subject to change without prior notice
Instructions on environment protection
Do not dispose this product in the usual household garbage at the end of its life cycle; hand it over at a
collection point for the recycling of electrical and electronic appliances. The symbol on the product, the
instructions for use or the packing will inform about the methods for disposal.
The materials are recyclable as mentioned in its marking. By recycling, material recycling or other forms of
re-utilization of old appliances, you are making an important contribution to protect our environment.
Please inquire at the community administration for the authorized disposal location.
PoSSIBLE CAUSE
The CD is inserted upside down.
The CD is dirty or damaged.
The Laser lens is dirty.
The CD door (4) is not closed.
The batteries are exhausted.
The earphone plug is not
properly inserted.
The volume is set too low.
The ON/OFF (5) switch on the
microphone is set to the OFF
position.
The microphone volume is set too
low.
AC 0V~50Hz / DC 6V, 600mA
DC 6V (4 X C/UM- batteries, 1.5V)
approx. 265 x 100 x 225 mm
approx. 1 kg with inserted batteries
SoLUTIoN
Reinsert disc with label side facing
up.
Replace or clean the CD.
Clean the Laser lens.
Close the CD door (4).
Replace the batteries or use the
AC/DC adapter.
Plug in again the earphone plug.
Increase the volume with OFF.
VOL. (17).
Slide the ON/OFF (5) switch to the
ON position.
Increase the microphone volume
with - MIC VOL + (8).
- 1 -