Bluetooth Operation; Speaker Mode - XD P326.87X Bedienungsanleitung

4.BLUETOOTH OPERATION

1. Press and hold power button to turn on the headphones. The blue indicator light will flash to
detect Bluetooth enabled devices near you. The blue indicator light will go out if no Bluetooth
device is detected within 5 minutes.
2. Turn on the Bluetooth on your mobile Device.
3. Search and connect with the device: SDC
4. Play/Pause as desired by pressing the Play & Pause button.
5. To answer an incoming phone call while using the headphones, press the Call pick-up & hang-up
button once. To end the phone call, re-press Call pick-up & hang-up button. Press the Call pick-up
& hang-up button twice to dial the last number dialed.
5.AUX PLAYBACK OPERATION
1. turn on the headphone
2. Insert a 3.5mm audio cable into the AUX jack on the back of the headphone. Connect the 3.5mm
cable to any audio device with a port.
3. Press the Multi-Function Dial button to play or pause music.
6.CHARGING THE HEADPHONE
1. The headphone has a built-in Lithium battery. The battery is rechargeable and provides
approximately 4 hours of continuous use at 80% volume when fully charged.
2. Use the micro-USB cable to charge the headphone. The red indicator light will illuminate when
the battery is low. The red indicator light will go out when the headphone is fully charged.
7. COMPATIBILITY
Devices equipped with BT 3.0 or higher (for details please refer to the user manual of that device).

8. SPEAKER MODE

To switch this item to speaker mode, turn the both earbuds completely to the side, like shown in the
steps below. The headphone will automatically switch to speaker mode. To go back to headphone
mode, simply turn the earbuds back to the starting position.
4