Werbung
Verfügbare Sprachen
Verfügbare Sprachen
Adjusting the cot bottom:
To change bottom position, insert a key, pen, or other small tool
into slot as shown and retract plungers on both ends.
To lower the BackSafe side, first lift up on top rail, then
squeeze triggers and lower.
To raise BackSafe side, lift up on top rail until latches lock
into position.
To change label, remove clear label holder from rail and replace
the paper label as desired.
Disassembly of Cot for storage:
1. Remove the mattress and bottom of the cot.
2. Flatten cot by bringing the two sides together.
3. Lift cot sides off ends.
Maintenance
Periodically inspect cot and mattress for cracks, tears, breaks,
loose parts, missing parts, and/or malfunctions. Remove the prod-
uct from service when any condition develops that might make
operation unsafe.
If refinishing, use a nontoxic finish specified for children's prod-
ucts.
All Community Playthings cots comply with BS EN 716 parts 1 and 2: Children's cots and folding cots.
Mattress provided conforms to BS EN 16890:2017 and BS 7177:2008+A1:2011 for Medium Hazard.
User Modifications
We cannot be responsible for modifications made by customers to
our products, without our supervision, testing, or evaluation.
Cleaning
Wooden parts: Wipe the wood parts, bite guards, and plastic rods
with a damp cloth and mild detergent. Dry immediately. Leaving
water or cleaning agent on the surface may damage the finish.
Clear End Panels can scratch easily: Dust with a soft, damp cloth.
Wash with dishwashing detergent and warm water. Use a clean
soft cloth, applying only light pressure. Rinse with clear water
and dry by blotting with a cloth. DO NOT USE: Window cleaning
sprays, kitchen scouring compounds, or harsh solvents.
Mattress: See manufacturer's label which is attached to the mat-
tress.
Accessories:
• G11 – Mattress only (fits all Community Playthings Cots)
• G13 – Fitted Knit Cot Sheet, light blue, 50/50 polycotton
• G14 – Fitted Knit Cot Sheet, white, 100% cotton
• S16 – Cot Blanket
Construction
Wooden components are manufactured from solid hardwoods
and hardwood plywood with a clear nontoxic finish. All edges
and corners are rounded for safety and ease of cleaning.
Mattress cover is silicone coated fabric. Mattress filling is coir
(coconut husk fibre) set in natural latex rubber and wool.
Clear end panels are made with 6mm plastic with a scratch
resistant coating.
Cots have 100 mm diameter locking castors.
Bite guards and telescoping rods are made of a rigid polymer, safe
for a child's mouth and easy to clean. Bite guards can be easily
replaced.
Ordering Parts
To order replacement parts, contact your Customer Centre with
a description of the part(s) needed and the ID Code from the
product.
Use only replacement parts supplied by
Community Playthings.
Werbung
