Sentinel Eliminator Installationsverfahren Seite 7

EN
Open
Fig. 6 Fig. 7
Step 6:
Set Isolation valves to open, as per Figure 7.
Step 7:
Refill system and check carefully for any leaks.
Step 8:
After filling the system with water, open bleed valve using a suitable
screwdriver to release air trapped in filter. Once water starts to escape, close
valve. After the system has been running, repeat if nessesary to release any
trapped air. Check again for leaks.
7
Eliminator V1-EM-12-14
Eliminator Instructions V1-EM (30-01-15).indd 7 30/01/2015 14:02