Electrical Schematic Diagram - APS 11903 Bedienungsanleitung

Electrical Schematic Diagram

Fuse
220 V ~ 50 Hz
Fuse
Install the Drop-in
The following requirements are required when using an embedded installation.
Products should be installed in the fl at base, such as wooden countertops, metal countertops,
stone countertops, the base thickness should be thinker than 10 mm (shown in Picture 1),
I need to far away from other heating equipment more than 50 mm.
Product installation hole size shown in Picture 2.
The lower part of the table shoult be kept ventilated, vent size should be larger than 30 cm
to prevent the internal completely closed.
After the installation, insert the plug directly into the socket, connect the power supply.
The socket should be installed in the easy position, unplug the plug and cut off the power once
abnormal happened.
Thermistor
Power board
heating plate
9
Control display
panel
,
2