physa MF-22 Bedienungsanleitung Seite 5

PURPOSE
This magnifying lamp is designed for the direct observation of small objects close to each other.
In case of damage resulting from an improper use of the device, the user shall assume all liability.
BEFORE FIRST USE
On receipt of the parcel, make sure the packaging is undamaged before opening it. If the packaging is damaged, please contact
your transport company and distributor within 3 days. Be as specific as possible when describing the damages. Do not turn
the package upside down! When transporting the package, please ensure that it is kept horizontal and stable. The packaging
materials (cardboard, plastic straps, polyurethane foam) should be kept at hand, so that the device can be sent back to the
service center, if needed, in the best conditions!
ENVIRONMENT OF USE
The room temperature must not be higher than 45°C and the relative humidity should be under 85%. Keep the device away
from hot surfaces. Operate the device on flat, stable, clean, refractory and dry surfaces, out of the reach of children and
people with mental disabilities. Make sure that the power outlet is always within reach. The power outlet must be properly
grounded and match the technical requirements of the device.
OPERATING PRINCIPLE
1
1. main switch
CONNECTION / SWITCHING ON
Never operate the lamp without light bulb or light bulb cover.
The power cord should be kept out of the way of people nearby. Insert the plug into the power outlet. Turn the lamp on
using the switch located underneath the lamp. „0" position = lamp off, „1" position= lamp on.
CHANGING THE LIGHT BULB
Before replacing the light bulb, always unplug the lamp.
Lamps that have just been used may be very hot: to prevent burns, let it cool down for a few minutes. Never use light bulbs
with a higher wattage than specified on the device.
Remove the lamp cover. Remove used / faulty bulb terminals with caution. Disconnect the bulb. Connect the new bulb, place
it in the terminals and put the lamp cover back in place.
1. locks
2. light bulb cover
2
1
1. locks
2. light bulb cover
3. light bulb
2
4. light bulb fasteners
3
1
4
Rev. IV 2016
8
TRANSPORTATION AND STORAGE
When transporting the device, avoid shaking it, dropping it and turning it upside down. Store it in a cool, dry place, free of
any corrosive gas.
CLEANING AND MAINTENANCE
• Unplug the device before cleaning.
• Use a mild, non-corrosive detergent.
• Small dirt particles should be blown off with compressed air. To clean the lens, use a special lens cleaning cloth. Never
use acid, alcohol or other solvents. The magnifying glass must not come in contact with any sharp object.
• Let the device dry before using it again.
• Store the device in a dry, cool location, free from moisture and direct sunlight.
REGULAR CONTROL OF THE DEVICE
Regularly ensure that the device is in good condition. Should it be damaged, please stop using it immediately and contact
your customer service to solve the problem.
What to do in case of problem?
Please contact your customer service and prepare the following information:
• Invoice number and serial number (the latter is to be found on the technical plate on the device).
• If relevant, a picture of the damaged, broken or defective part.
• It will be easier for your customer service advisor to identify the source of the problem if you give a detailed and
precise description of the matter.
The more details you give, the quicker the customer service will be able to solve your problem!
CAUTION: Never open the device without the authorization of your customer service. This may void the guarantee!
Rev. IV 2016
9 9