Werbung
Verfügbare Sprachen
Verfügbare Sprachen
EN
1,7 Pushbar
The pushbar connects to the protruding
tube parts of the roller cages. The
pushbar has two settings: curving up
for tall users and curving down for
short users. Push the two ends of the
pushbar in the released tube ends.
The pushbar is secured with the tube
locking pins supplied.
1,8 Rear light
The KidCar Comfort and Cocoon come
standard with a battery rear light. The
rear light has not been fi tted by the
manufacturer to prevent any damage
during transport. Remove the lock
nuts and tighten the bolts using a no.
8 spanner. Make sure that the rear is
fi rmly secured but do not overstress
the bolts.
2 Daily use of the KidCar
2.1 Seat belts:
The KidCar Cocoon and Comfort
have been fi tted with a special safety
harness. Start adjusting the fi ve-point
seat belt on the child's tummy. The
shoulder belts are adjusted up and
down. For optimal safety the belts
should be level with the top of the
child's shoulders. The shoulder cross
belt is always used in combination with
the lap belt.
With one child sitting in the middle, the
two centre seat belts are to be used.
In that case the two outside belts are
not being used. The central part of the
seat belt set is moved to the centre.
Remember to tightly secure the belts
around the child's shoulders and lap.
The belts prevent the children from
spontaneously stepping out of the cart
or moving forward during a sudden
stop.
2.2 The parking brake
Stand behind the KidCar and use a toe
cap to push the brake lever down into
the parking position or move it up to go
for a ride.
2.3 Storing the drawbar when going
for a walk
Look for a hook on the fl ag holder
at the back of the KidCar. Lower the
drawbar in the opening of the pushbar
(the coupling facing up), and attach the
end of the tube to the hook. The top of
the drawbar rests against the right side
of the pushbar. Secure the drawbar by
winding the safety ribbon around the
tube of the pushbar.
2.4 Rolling up the frontcover
The KidCar Cocoon and Comfort are
having a 2-in-1 front- and mosquito
cover. Zip fasteners are used to open
and close the frontcover. Use the
ribbon at the centre to roll the front-
and mosquito cover up and hold it in
place. To leave the rear window open,
unzip and fold the window inwards.
Close the zips up to the folding line. In
that way you will be able to control the
amount of fresh air coming in.
Unzip to the obstruction and roll the
front window from the bottom up. The
ribbon that holds the window in place
will appear. Push the ribbon over the
rolled-up window and through the
ring at the back of the ribbon. Use the
velcro or buckle to secure. To do so,
the rear window must also be rolled up
or folded inwards.
2.5 Complete front cover
It is also possible to fully roll up the
front cover. Roll the coverfrom the
bottom up. Make sure that the ribbon
is not also rolled up, but is laying loose
instead. Run the ribbon from the back
over the front cover and through the
ring that is now showing below the
hood. Pull the ribbon tight and secure
with the velcro or bucle. The cover may
have to be pushed a little further to the
back to be adequately secured.
14
Werbung
