Overview Of Switching Times; Adjust Or Reset Switching Times; Meaning Leds; Fuse Replacement - TechGrow Seconds Timer Pro Handbuch

#01 @17 : 10 : 00
Mo-Fr @18 : 50 : 30
with the duration of the ON time, which is indicated
•
by a + plus sign. In the next example, the device is
switched on at 5:10 p.m. for 21 seconds (the device
is switched off at 5:10:21 p.m.).
#01 @17 : 10 : 00
Mo-Fr + 00 : 00 : 21

2.3 Overview of switching times

The main screen is displayed:
Wed 14 16:42:34
If you turn the PTK quickly, an overview of the
programmed switching times is displayed. If a certain
circuit number is not programmed, it will not be
displayed.
#01 @17 : 10 : 00
Mo-Fr + 00 : 00 : 21
#04 @20 : 30 : 00
Mo-Fr + 00 : 01 : 30

2.4 Adjust or reset switching times

If you want to adjust the switching times, you can do
this according to the steps in section 2.2. You choose
the circuit number, for example # 03 and adjust the
day(s) and times, or you delete this setting entirely by
selecting Dis.
If you want to delete all switching times in one go, you
can do so via the start-up menu. Switch the Seconds
Timer Pro on again and press the PTK for a few seconds
____________________________________________________________________________________________________________________________
TechGrow | Innovative Growing Solutions
during the start-up. Select "Reset timers" in the next
screen.
Set clock
=> Reset timers
Continue
Press the PTK to erase all switching times.
Resetting
all timers
All timers are reset. You will return to the main screen.

3. Meaning LEDs

The Seconds Timer Pro has two LEDs:
Green: the Seconds Timer Pro has switched on the
•
relay (pulse).
Red: the Seconds Timer Pro has switched off the
•
relay (pause).

4. Fuse Replacement

In the event of an overload or short circuit, the internal
fuse of the Seconds Timer Pro will blow. To replace the
fuse you have to open the Seconds Timer Pro. Complete
the following steps:
1. Remove the plug from the socket.
2. Open the housing by unscrewing the 4 screws on
the back of the Seconds Timer Pro.
3. Locate the fuse and remove it.
4. Insert a new 10 amp fuse.
5. Screw the 4 screws to close the housing.
Your Seconds Timer Pro is ready for use again.
9