Wireless Operation - Chauvet Professional Ovation H-55WW Kurzanleitung

EN

Wireless Operation

In optimal conditions, the Ovation H-55WW can operate up to 300 m (900 ft) away from the W-DMX transmitter. The
W-DMX receiver in the Ovation H-55WW must be paired with the W-DMX transmitter for wireless operation.
Initial Setup
1. Turn the W-DMX transmitter on.
2. Connect the W-DMX transmitter to a DMX controller.
3. Place the Ovation H-55WW within 300 m from the W-DMX transmitter.
4. Disconnect any DMX cable from the Ovation H-55WW.
5. Turn the Ovation H-55WW on.
Wireless Configuration
To configure the wireless mode, press and hold the button next to the indicator lights.
Mode
OFF
RECEIVE MODE
W-DMX operation can be interrupted or inhibited by liquid masses between the transmitter and
receiver such as water, snow, or people. For best results, keep the area between the transmitter
and receiver clear of any liquid mass.
Mounting
Before mounting this product, read the
mounting clamps are capable of supporting the weight of the product. For our Chauvet line of mounting clamps, go to
http://trusst.com/productcategory/truss-clamps/.
Product Mounting Diagram
Overhead Mounting
3
QUICK REFERENCE GUIDE
Wireless Indicator Light
Green/Red lights off
Green light flashing slowly
Red light off
Red light on
Red light flashing slowly
Red light flashing quickly
Safety Notes. Use at least one mounting point per product. Make sure the
Mounting Clamp
Pendent Mounting
Description
Fixture is off
In Receiving Mode
Waiting for wireless connection
Connected with W-DMX Control and there is a DMX input signal
Connected with W-DMX Control but no DMX input signal detected
Connected to W-DMX Control but the signal is weak
Scone kit
Side/Wall Mounting
Ovation H-55WW QRG Rev. 7