zeuss XT-9 Bedienungsanleitung Seite 2

Getting started with the XT-9:
Press the ON/OFF Button to turn the XT-9 on/off. When you turn the XT-9
on the light color is warm (3000 Kelvin) and the light brightness is 100%. At
ON Mode keep the ON/OFF button pushed in to cycle through dimming
modes. (10-100%)
Press the ON/OFF button again within 2 seconds after switching ON to
switch to cold light (6500 Kelvin) 100%. At ON Mode keep the ON/OFF
button pushed in to cycle through dimming modes. (10-100%).
Press the ON/OFF button again within 2 seconds after switching mode to
switch to middle light (4500 Kelvin) 100%. At ON Mode keep the ON/OFF
button pushed in to cycle through dimming modes. (10-100%).
Press the ON/OFF button again within 2 seconds after switching mode to
switch to strobe mode.
If you press the ON/OFF button longer as 2 seconds after switch on/switch
mode the XT-9 will turn OFF. You can also press the ON/OFF button after
strobe mode to turn the XT-9 off.
Fold the carrying handle out to hold the XT-9 conveniently. For hanging use
the hanging hook at the bottom of the XT-9 can be used, optionally the
lamp cover can be removed to make the XT-9 smaller (twist the lamp cover
left to remove)
When the XT-9 is almost empty (<10%) the ON/OFF button will light up red
to warn you to recharge the lantern. Charging ports can be found under the
rubber cover on the backside of the XT-9 lantern.
The included Micro USB cable or any other Micro USB can be used for
recharging in combination with any 5v 1A USB wall or car adapter. A LED
indicator shows the charging status, red means still charging and green
means fully charged. A full recharge will take around 6-8 hours. Simply plug
the Micro USB side into the lantern and the USB side into a 5v 1A wall/car
adapter or other USB device.
The XT-9 can also be used as a power bank. You can simply use the USB
output on the XT-9 lantern to recharge any USB device. Simply plug your
2