V. Orlandi GA25 Einbau-, Bedienungs- Und Wartungsanleitung Seite 34

INSTALLATION, OPERATING AND MAINTENANCE INSTRUCTIONS INSTALLATION, OPERATING AND MAINTENANCE INSTRUCTIONS
2) Reverse slowly the towing vehicle. The drawbar eye has to enter completely into
the muzzle of the drawbar coupling body (1) by operating the operating the
release latch (4). This makes the coupling pin (3) fall down immediately.
For drawbar coupling GA250 and GA251, the
security pin (8) is back in its position.
8
5
4
1
ATTENTION: control that the coupling up was carried out properly; control
that the opening handle (13) is down in order to ensure a sure locking of
the coupling pin (3).
For the drawbar coupling GA250 and GA251, the security pin (8) has to
be completely re-entered in its position.
ATTENTION: in case the coupling would not close perfectly try to move
the towing vehicle or the trailer back and forth about 50 cm to assist the
drawbar eye to find the right position and make the coupling close; or
operate the closing handle (5).
If the coupling will not close perfectly it is absolutely forbidden to travel.
Contact the closest workshop for the solution.
DRAWBAR COUPLING GA25
8
13
3
PAG.
10/24
CHAP . 3
REV. A
OK NO