Tyco Minerva PRN800 Bedienungsanleitung

PRN800 MX Printer
Paper roll replacement
1
Fig. 3: Paper change
1 –Paper drive spindle
2 –Paper roll retaining bar
1 Undo the two Supadrive™ screws and
remove the printer mechanism front cover.
2 Pull out the paper drive spindle.
3 Pull out the paper roll retaining bar and slide
off the old paper roll.
4 Put the new paper roll onto the paper roll
retaining bar with the paper feeding from the
rear.
5 Press the paper roll retaining bar back into its
grooves.
6 Feed the paper over the paper drive spindle
and press the spindle back into its retaining
grooves.
7 Feed the paper through the printer mecha-
nism front cover slot and refit the retaining
screws.
120.415.535_17A-03-PRN, doc. version 5.0, 29. November 2018
© 2018 Johnson Controls. All rights reserved. All specifications and other
information shown were current as of document revision date and are subject
to change without notice.
www.zettlerfire.com
Tyco Fire & Security GmbH, Victor von Bruns-Strasse 21, 8212 Neuhausen
am Rheinfall, Switzerland
MZX Fire detection system
Ordering information
Item Order Code
Spare paper roll (pk of 5) 557.301.014
Fig. 4: Order codes
2
Language Constraints
Languages Supported
The PRN800 supports Language Code Page 850
which includes the following
 Western European languages:
– Danish
– Dutch
– English
– French
– German
– Italian
– Norwegian
– Portuguese
– Spanish
– Swedish
Unsupported Languages
The PRN800 does NOT support the following
 Central European languages:
– Bosnian
– Croatian
– Czech
– Hungarian
– Polish
– Romanian
– Serbian
– Slovak
 Eastern European languages that use the
Cyrillic alphabet including Greek and Russian.
No other alphabets are supported.
MZX Fire detection system
PRN800 MX Printer
Part No. 557.202.024
1
Fig. 1: PRN800 MX printer kit
1 –Paper feed button
NOTICE
The PRN800 Printer kit is designed
for use within the MX/T2000
battery housing.
The PRN800 is fitted to the front cover of the MX
/T2000 battery housing and is powered from the
panel PSU830 Power Supply via an FB800 fuse
board. The use of a thermal printer mechanism
ensures high reliability, only the paper roll
requires replacement periodically.
Fixing instructions Doc. version 5.0
PRN800 MX Printer
CAUTION
The printer assembly must be
powered via a FB800 fuse board
using a 0.5 A time delay fuse.
A free cable entry hole is required in
both the controller and battery/
expansion housings.
Any cable runs must be protected
by conduit or trunking.
Information
For a complete list of the PRN800 sup-
ported and unsupported languages, see
"Language Constraints" on page 4.
1/4