Herunterladen Diese Seite drucken

Thermon Terminator ZP-MI-WP Bedienungsanleitung

Werbung

Terminator
ZP-MI-WP
TM
Power Connection Kit
INSTALLATION PROCEDURES
For Use with MI Mineral Insulated Heating Cable Sets

Werbung

loading

Inhaltszusammenfassung für Thermon Terminator ZP-MI-WP

  • Seite 1 Terminator ZP-MI-WP Power Connection Kit INSTALLATION PROCEDURES For Use with MI Mineral Insulated Heating Cable Sets...
  • Seite 2: Installation Procedures

    Junction Box Base with O-Ring nance, a ground-fault protection device is required. Wall Mount Bracket • Installation must comply with Thermon requirements and be M5 Screws installed in accordance with the regulations as per the norm Lock Washers EN IEC 60079-14 for hazardous areas (where applicable), or any other applicable national and local codes.
  • Seite 3 Terminator ZP-MI-WP INSTALLATION PROCEDURES Mounting Method 2: Secure wall mount Mounting Method 3: Secure XP-1 mounting Mounting Method 1: Secure wall mount brack- bracket to mounting surface using screws, bracket to pipe using pipe bands. Secure wall et to mounting surface using pipe band. washers, and nuts (user supplied) mount bracket to XP-1 using screws, washers, and nuts (user supplied)
  • Seite 4 Terminator ZP-MI-WP INSTALLATION PROCEDURES Mount junction box base on expediter. Make Install power cable (if necessary). Install quick mount terminal blocks and tighten sure to align slots to properly orient junction screws (if necessary). box base. Tighten nut with Terminator-LN- Tool.
  • Seite 5 3 Phase Wye Connection Power Connection (1 to 3 MI Cable Cold Leads) When connecting three MI cable cold leads, make sure to remove jumpers from ter- minal blocks. When connecting only one MI cable cold lead, contact Thermon for design assistance.
  • Seite 6 Verwendung bzw. Installation und Wartung hervorgerufen werden können, ist ein Fehlerstrom-Schutzschalter (FI) je • L’installation doit être conforme aux recommandations données par Thermon, et être faite dans le respect des normes électriques EN Heizkreis vorgesehen. IEC 60079-14 applicables aux zones classées, ainsi que tout autre code local ou national du lieu considéré.
  • Seite 7 THERMON . . . The Heat Tracing Specialists ® www.thermon.com European Headquarters Corporate Headquarters • • For the Thermon office nearest you Boezemweg 25 PO Box 205 100 Thermon Dr. PO Box 609 • • visit us at . . .