LIVARNOLUX HG02189 Montage-, Bedienungs- Und Sicherheitshinweise Seite 10

use to see if there are any signs of damage.
Never attempt to use the product if you notice
any damage.
The product should not be used if the cover
is torn or the mounting suspension shows any
sign of damage.
Before making use of the product, make certain
that it has been installed correctly and is hang-
ing safely.
Never use the product as a swing.
RISK OF INJURY! Do not sit on or jump into
the product with a jolt.
No liability is assumed for accidents due to
improper use and failure to observe these safety
instructions.
Assembly should always be carried out by adults.
Please ensure that the product is not used as a
swing, climbing frame, or gym apparatus.
Do not stand in the product, do not climb in
feet first, and do not put your head through the
hanging ropes.
lf possible only use the product on floors with
shock-absorbing properties such as carpet or
outdoor grass in order to minimise the risk of
injury in case of falling out of the product.
Before mounting the product on the ceiling,
make sure that the ceiling or respectively, the
wooden beam, is suited for installing the prod-
uct. If necessary, consult a specialist.
The product should be used by only one per-
son at a time.
Make sure that the ceiling or respectively, the
wooden beam to which you chose to attach
the product has double the maximum load
bearing capacity.
Caution - danger of strangulation! Remove the
rope from the ceiling bracket when the product
is not in use.
Mounting
To hang the product, be sure to use only
the mounting package included in the
delivery or other suitable stands or
suspension elements.
10 GB/IE
Before mounting the product on the ceiling, make
sure that the ceiling or respectively, the wooden
beam has sufficient load bearing capacity. The an-
chor plugs included in the delivery are suitable for
use in solid concrete ceilings.
The screws included in the package can be used
for solid wood.
For questions regarding mounting material to be
used in the case of other ceiling constructions
you may want to consult a specialised retailer.
Install the ceiling mounting fixture into the
supporting material (e.g., concrete ceiling or
sturdy wooden beam) as shown in Fig. B and C.
When attaching the unit to the ceiling, please
note the following specifications:
For mounting in a solid concrete ceiling:
Pilot hole diameter 5–6 mm
Finish boring diameter 8 mm
Bore hole depth 60–70 mm
For mounting in solid wood:
Pilot hole diameter 2.5–3 mm
Bore hole depth 30–35 mm
Note: The anchor plug must end up flush with the
ceiling.
Note: Make sure that the suspension device is
installed correctly and check for wear at regular
intervals. In the case of damage, the suspension
device should be exchanged.
The individual suspension cords must hang straight
and may not be twisted or knotted as this will result
in additional strain on individual strands. You may
also attach the product to a tree or a beam by
means of ropes.
Hanging the chair
1. Tie the end of the rope
shown in Figure D. Note that the slip knot must
be at least 10 cm long in order to avoid prob-
lems attaching it to the ceiling fixture.
2. Pull the slip knot through the guide of the ceil-
ing fixture and attach it to the hook (Fig. E).
5
3. Thread the end of the rope
holes of the hook
6
into a slip knot as
4
through the
4
(Fig. F) and tie a slip knot