Pre-Startup Check - Toshiba SF-P2218EEU Bedienungsanleitung

OPERATION INSTRUCTION

Pre-startup check

1. If power line is in good condition.
2. Product power is 220-240V AC, bearing capacity of product socket is no lower than
10A; otherwise, accidents would occur.
How to use
Key Function Description
On the idle mode, press on-off key to enter the power-on mode, the warmer starts work-
ing and the whole machine runs under the previous remembered mode and tempera-
On-off key
ture. On the power-on mode, press on-off key to enter the idle mode, the warmer stops
working. (Note: On the heating mode, draught fan will operate for 15 seconds at low
wind speed after power off.)
After power-on, the warmer is in the intelligent mode by default. Repeatedly press the
Mode key
"mode key", the warmer shifts in circular order among "intelligent mode, low warm wind,
high warm wind, strong warm wind, breeze, and gentle breeze".
On the working state, press "+" or "-" keys to set the working temperature. The tempera-
ture setting range is 5°C~35°C and every temperature value is of 1°C difference. The
seconds after the setting. After room temperature reaches the set temperature, display
+ and – key
screen blinks for 10 seconds and heating unit stops working; when temperature is below
the set temperature, machine restarts to heat. In low warm wind, high warm wind, and
strong warm wind modes, it can be set to without temperature control, whose display
icon is "--".
In the power-on mode, press this key to select the timed shutdown setting. The timing
indicator lights up, the temperature display icon lights off, and display screen blinks and
shows the rest time of last setting. Press "+" or "-" keys to set shutdown time, the setting
Timing key
without pressing within 5 seconds. If the set time is 0, it means cancelling the timing set-
ting; if the set time is not 0, the machine shuts down automatically, enter the idle mode
and turns off the timing icon when reaching the set time. Set again the time after time
setting, and the machine is retimed.
In the idle mode, press this key to set timing power-on, of the same operation as timing
shutdown. The time unit of the timer is hour.
Sway key
In the power-on mode, press this key to start swaying, and press again to stop swaying.
[Starting up]
Turn power switch to "I" marked position, then press on-off key on the control panel to start
up the machine. After starting up, the machine runs on the mode of last power off.
[Light screen off function]
When the machine is on the working state, the screen automatically lights off and operating
mode icon retains up if without operation within 1 minute. Press at the same time the
key and "-" key for 2 seconds to close the light screen off function. Press again at the same
time the key and "-" key for 2 seconds to open the light screen off function.
13