Operation Cycle; Maintenance, Storage And Transportation - Greencut MMA180 Betriebsanleitung

OPERATION
-
Set the ON/OFF switch to the ON position, so that the power indicator and the fan come on.
-
Adjust the current as per your needs using the current control.
-
Under normal circumstances, the electrode and the corresponding welded values are:
Electrode diameter (mm)
Current (A)

OPERATION CYCLE

Make sure that the machine works within the indicated parameters on the technical data label:
• X: Operation cycle (% of minutes) in which the welding machine can work continuously to a certain current
without overheating. For example: 60% is equivalent to 6 minutes working and 4 minutes without working.
• If these work times are exceeded, the overload warning light will come on and you must stop working.
ATTENTION: If the overload warning light comes on, stop working and wait until the engine cools
down until the light comes off before using the machine again. Failure to follow these instructions
will void the guarantee.

MAINTENANCE, STORAGE AND TRANSPORTATION

• Remove dust from the machine and always clean the fan outlet before use. It is recommended to clean the welder
once a month if it is not used.
• Check the connections.
• Keep the machine dry.
• Allow the equipment to cool completely before transporting or storing.
• Avoid a location exposed to sunlight when placing the machine in a vehicle. If the machine is left in a locked
vehicle for many hours, high temperatures inside the vehicle can cause the fuel to evaporate and cause a possible
explosion.
• Always store the product in a clean, safe, dry place with temperatures between 0º and 45ºC.
• The equipment is not weatherproof and should not be stored in direct sunlight, high temperatures or in damp
places.
• Never store the equipment in places where flammable materials, combustible gases or liquids, etc. are present.
• To reduce the risk of fire, keep the machine clean by removing traces of material, oil and grease.
• Store the machine out of the reach of children.
Ø1.6 Ø2.5
35-50 60-130
39
EN
Ø3.2
90-180