Anhang - Walker MT Serviceanleitung

ANHANG

10
Schmier Punkte - MT, MTL, MTEFI, MTLEFI
Ident
No.
Location
1 Deck Caster Wheel Fork Pivot
2 Deck Caster Wheel Bearing
3 Tee Gearbox, Deck
4 Blade Drive Gearbox
5 Universal Joint Shaft Assembly Grease
6 Pivot Assembly, Tilt-Up Deck
7 Deck Support Arm Socket
8 Body Hinge Point
9 FSC Actuator Rod Pivot Pins
10 FSC Lever Pivot
11 FSC Lever Fork
(Grease Slide Area)
12 (FSC) Friction Body Pivot
13 Steering Lever Pivot
14 Deck Support Arm Pivot
15 Deck-to-PTO Coupling
(Grease Slide Area)
16 Universal Joint Tube Assembly Grease
17 Universal Joint Quick Connect
Spline (Grease Slide Area)
Parking Brake Lever
18
19 Gear Axle
20 Belt Tightener Pivot,
Jackshaft Drive
21
Throttle Control Cable Ends
22 Clutch Actuator Push Rod
23 PTO Clutch Lever Pivot
24 Belt Tightener Pivot,
PTO Clutch
Schmiermittel No. Ident
Type Places No.
Grease 2
Grease 2
* 1
Oil
2
*
Oil
** 1
Grease 4
Grease 2
Oil 2
Oil 2
Grease 1
Grease 1
Grease 1
Grease 4
Grease 2
Grease 1
**
1
Grease 1
Grease 1
*** 2
Oil
Grease 1
Oil 2
Grease 2
Grease 1
Grease 1
Location
25 Brake Actuator Rod and Brake
Band Pivot Pins (Clevis)
26 Brake Actuator Pivot
27 Catcher Hinge Point
28 Rear Wheel Bearings
29 Engine Oil
30 Choke Control Cable Ends
(Models MT and MTL only)
31 Belt Tightener Pivot,
Blower Drive (GHS Model Only)
32 Belt Tightener Pivot,
Ground Drive
33 PTO Gearbox Dipstick
34 Hydrostatic Drive
35 Choke Control Pivot
(Models MT and MTL only)
36 Throttle Control Pivot
*
Gearboxes are permanently lubricated and sealed requiring
no scheduled lubrication. Oil level should be checked only
when an oil leak is noted.
Lubrication in this section.
**
Grease every eight (8) hours.
***
Refer to Gear Axle Lubrication, Engine Oil, Tractor PTO
Gearbox Lubrication, and Hydrostatic Transmission Fluid
in this section.
NOTE: DGHS42 Tilt-Up Deck is shown for reference.
Schmiermittel No.
Type Places
Oil 3
Grease 1
Oil 2
Grease 2
***
1
Oil
Oil 2
Grease 1
Grease 1
***
Oil 1
*** 2
Oil
Oil 1
Oil 1
Refer to Mower Deck Gearbox
For other