Herunterladen Inhalt Inhalt Diese Seite drucken

EasyLine PC700 Benutz Und Wartungsanleitung Seite 6

Inhaltsverzeichnis

Werbung

Verfügbare Sprachen
  • DE

Verfügbare Sprachen

  • DEUTSCH, seite 11
• Never use your fingers, kitchen utensils or similar to push ingredients down the feed tube! Use the accompanying
tamper.
• Never stick fingers or other objects in the spout.
• Never touch the moving parts of the appliance until it has come to a complete stop.
• The centrifuge bowl must be handled with care, as it contains extremely sharp parts.
• Never use if the centrifuge bowl is damaged.
• Do not leave the appliance running nonstop for more than 3 minutes at a time. If the appliance has been running for 3
minutes, allow it to cool down for 20 minutes before you use it again.
This appliance is not intended for use by persons(including children) with reduced physical, sensory or mental
capabilities, or lack of experience and knowledge, unless they have been given supervision or instruction concerning
use of the appliance by a person responsible for their safety.
Children should be supervised to ensure that do not play with the appliance.
If the appliance cord is damaged, it must replaced by the vonder.
Ensure that the cord is fully extended.
Do not allow the cord to hang over the edge of a table/counter, and keep it away from hot objects and naked flames.
Check regularly that neither cord nor plug is damaged and do not use if they are, or if the appliance has been dropped
or damaged in any other way.
If the apparatus or plug is damaged, it must be inspected and if necessary, repaired by an authorised repair engineer,
otherwise there is a risk of electric shock. Never try to repair the appliance yourself.
Avoid pulling the cord when removing the plug from the socket. Instead, hold the plug.
Check that it is not possible to pull or trip over the cord or any extension cord.
 
Technical information             
Power:
Voltage/frequency:
Speed:
Operation Instruction                                                                                                                     
Assembly before use
Place the motor section (3) on a flat surface, e.g. a kitchen counter, and make sure it is standing firmly on the four
suckers underneath.
Place the base(6) on the motor section so that the spout (5) fits in the slot on the side of the motor section.
Push the fruit pulp holder (2) up under the drain edge on the base so that it locks on the foot of the motor unit tightly.
Carefully lock the centrifuge bowl (7) onto the base.
Be careful not to touch the sharp parts in the bottom of the centrifuge bowl.
Make sure that the centrifuge bowl sits properly on its base, so that the gear on the bottom of the bowl engages the
gear in the base.
Make sure that the centrifuge bowl doesn't sit too loosely on the base and that it rotates evenly.
Place the lid (10) on the appliance so that it covers both the fruit pulp holder and the centrifuge bowl unit. Make sure
that the lid fits tightly onto the base.
Turn the lock mechanism (4) to the vertical position and make sure that it engages the lid and locks it fast. The lock
mechanism makes a clicking sound when this is done correctly.
Place a glass, bowl or other suitable container under the spout.
The apparatus now ready for use.
Preparing fruits and vegetables for juicing
Always wash fruits and vegetables thorougly before juicing.
It is not necessary to remove seeds, pits or thin peels before using the appliance.
Fruits with thick peels such as oranges and lemons must be peeled before juicing. It is particularly important to remove
all the peel (including the pith), as even small amounts of peel can impart an unpleasant taste to the juice.
It is also necessary to remove large pits (such as plum and apricot pits) to avoid damaging the appliance.
Large fruits and vegetables should be cut into pieces that can fit into the funnel (9).
Use
Start the appliance by turning the =n/Off button to position "1" (low speed) or position "2" (high speed).
The low speed setting is suitable for juicing soft fruits and vegetables.
The high speed setting is suitable for juicing harder fruits and vegetables.
Feed the selected fruits and/or vegetables into the appliance through the funnel a little at a time, pushing them down
using the tamper (1).
Make sure that you turn the tamper so that the groove in the tamper fits into the funnel properly.
Long vegetables such as carrots should be fed into the funnel pointy end first.
Press the fruits and/or vegetables gently with the funnel. Too much presser reduces the amount of juice extracted and
can damage the appliance.
                                                                                                       
PC700
850 w
230V/1N/ 50Hz
2800 rpm
WF-A6000
550 w
230V/1N/ 50Hz
2800 rpm
   

Werbung

Inhaltsverzeichnis
loading

Verwandte Produkte für EasyLine PC700

Diese Anleitung auch für:

Wf-a6000

Inhaltsverzeichnis