General Features - AVS Electronics BF 100 A Bedienungsanleitung

GENERAL FEATURES

8
7
6
5
4
3
2
1
ON
1 2 3 4
S2 S3 S4
LD2
E
LD3
LD4
N
S7 S8
G
NC
C
NO
ALLARME
- Smoke detection beam made of a Transmitter and a Receiver, capable to detect and determine
the quantity of smoke which is present in the protected area.
- The board is equipped with a view-finder, placed on one side, allowing a rough alignement
with the reflector given within.
- The beam is equipped with a device (Led/display module) to use for calibration and check of
signal received.
- At first supplying, the board makes a self-calibration which will be repeated every 2 hours in
order to compensate masking caused by dust on lenses and reflector.
- Adjustable sensitivity to get a better intervention threshold according to distance.
- The beam has alarm outputs as well as fault condition and consumption-alarm outputs, which
allow connection to standard fire control units.
- The beam has a serial interface in order to connect up to 4 units to the remote panel (BR100)
showing the same indications as shown by led/display module and leds.
RX
S5
S9
S6
+ -
NC
C OUT A B
NO
GUA STO +F
ON
1 2 3 4
LED
S2
ROSSO
- 16 -
TX
- +
S5
S6
+ -
IST0675V2.2